WARNINGS TO BE RESPECTED
5
- This kit must be connected with the 18V/1.5A transformer provided.
- Connect up all the elements before you power up the kit
- Leave a minimum of 25 cm between the interior monitor and any other installation.
- Never cover the monitor or transformer.
- Never expose the exterior camera to re or very bright light.
- Never expose the elements to steam or to a major source of dampness.
- The system can be used in all climates.
- Position the elements on vertical, smooth supports, respecting the explanations in the manual, notably concerning the street panel’s
seal.
If not, the warranty will be void.
- Holding down the electric lock’s opening button for a long time may damage it.
- The interior monitor must not be installed near a TV set or in a place where the dampness or ambient temperature is too high.
- Never touch the camera with your ngers. Do not open the monitor, the camera or the transformer. This will automatically void the
product warranty.
- Clean glass parts with a soft cloth. Cleaning uids that may cause corrosion are not recommended.
- Do not cause any impact on the elements as their electronics are fragile.
- No images will be visible on the interior monitor if there is direct light on the camera.
- The image may be altered or cut out slightly when the lock or automatic opener are activated.
- The image may be altered or cut out slightly when motorbikes or bicycles pass near the exterior camera.
To Next Page
Loading...
