Scully 280 Series - Page 11

o
o
SECTiON 3
OPERATING INSTRUCTiONS
o
0)
o
• •
0
,
0
•
'0 0 0:06666
o
o
-
Figure3_I.Tape Transport Control Panel
3.1.
The operat i ng controls lor the 280
Series tape tranSpOrts are located on the op_
erations control panel on the bottom 01 the tape
transpOrt n,.chanism (see rig. 3-1). These are
from lelt to rill:ht. the AC Power Switch. Re_
Record SWitch. Lelt and Right Reel Ten_
sion Rewind, f"ast t'orwaro. StoP.
Start. Capst'-ll Speed Switch and Kdit. Kqualiz.a_
tion is switched with caps t an speed.
The ,-mpllfier panel contro ls a r e shown
In rig. 3- 2. From left to right. these are the
Record Level Control (A), Function Switch (B).
Monitor Switch (C), and Pla,'back Level Control
(D) . The Record Indicator Pilot Light (F). VU
Meter (G), Line Termination Switch (H), and
l'oone Jack II) are also l ocated on th e amplifier
COnlrol [(Ind,
Other amplifier adjustments. which are
not normally made excef( when cbanglng the
ty pe of tape ',sf><! or in servicing the recorder.
are located underneath the panel dress strip
(E), This S'.rip may be remove<! by loosening
the three captive screws,
3.2, CO:iTROLS AND INDICA TORS
3,2. 1, Tape TranSpOrt Ope",tionControl Panel
figure 3-1.)
a. Electronic ardme-
chanicaC The pilot
lamps on the op_
erations control panel and the VU n,eter On the
amplifier assembly are roth illuminated when
the
AC Power Switch is in the 0:> pOsition.
b.
Kecor<!_A red illuminated push_
button COntrols the record function when the
mode switch on the amplifier panel is in lIle
LINE
or M1C poSition. The button,
with the rf><! reeord pilot lamp on the amplifier
panel, remains illuminate<! as long as the ma-
chine is in the record mode.
c, Reel Si.e S"'itches for Left &; Right
Reels ::.
These are a paH of double throw
$"'ilches "'hleh permit individual adjust""nt of
tape te nsion lor 7 irlCh and 10-1 / 2 inch reels in
Start mode only . This does not permit braking in
!'ast Forward or Rewind with dissimilar reels