SCULPFUN iCube Pro-5W - Engraving Parameter Settings; File Naming and Size Adjustment; Set Laser Mode and Air Assist; Set Engraving Speed and Power

iCube Machine User Manual
5.3 Engraving parameter settings
① Name the file name
② Adjust engraving
size
③ Set engraving speed
④ Set engraving power
⑤ Move laser position
⑥ Engraving preview
⑦ Upload engraving
file
⑧ Air assist switch
(stay tuned)
① ②
③ ④
⑤ ⑥ ⑦
⑧
① After the upload is
completed, the
machine will start the
engraving task
② Displays the engraving
progress bar, and the
bottom can control the
machine to pause and
start
③ Just wait for the
engraving to be
completed
5.4 Engraving interface
8