SDC 920 EntryCheck - Erasing All Entry Codes; Changing Master Programming Code; Configuring the Sense Input; Keypad Lockout Output Configuration

Configure Sense Input Default: Door Sense
51#2 
/85.*5.*DN
Press: 10 # Input #
Input=0 for Door Sense; =1 for Inhibit
4/85.*5.0
  1#
#?268>./.*8J#
( 
"0/8!O!8#
4*DN0
#"89<"#?
##$
 "
Select Forced Entry Output Default: No Output
5#"/85.*5.

+,
Press: 11 # Output #
Output=Output to Activate(0-4)
1=Main Relay; 2=Auxiliary Relay; 3=Output #3; 4=Output #4;
0=No Output
Select Door Ajar Output Default: No Output
5#"/85.*5.
(13
3 6%2
Press: 12 # Output #
Output=Output to Activate (0-4)
1=Main Relay; 2=Auxiliary Relay; 3=Output #3; 4=Output #4;
0=No Output
Select Keypad Active Output Default: No Output
5#"#
0
"
Press: 14 # Output #
Output=Output to Activate(0-4)
1=Main Relay; 2=Auxiliary Relay; 3=Output #3; 4=Output #4;
0=No Output
Select Keypad Lockout Output Default: No Output
5#"#+,
(

Press: 13 # Output #
Output=Output to Activate (0-4)
1=Main Relay; 2 = Auxiliary Relay; 3=Output #3; 4=Output #4;
0=No Output
Select Alarm Shunt Output Default: No Output
5#"
1&
2 
Press: 15 # Output #
Output=Output to Activate(0-4)
1=Main Relay; 2=Auxiliary Relay; 3=Output #3; 4=Output #4;
0=No Output
Select Request-to-Exit Output Default: No Output
5#"#8?.$
 
Press: 16 # Output #
Output=Output to Activate(0-4)
1=Main Relay; 2=Auxiliary Relay; 3=Output #3; 4=Output #4;
0=No Output
REX input terminates toggle of Main or Aux. Relay
Main Relay On-time Default: 02 Seconds
578"#
K-./#78"
Press: 21 # Seconds #
Seconds=Output time in seconds (1-60)
Auxiliary Relay On-time Default: 02 Seconds
5!$8"#
Press: 22 # Seconds #
Seconds=Output time in seconds (1-60)
)@A*5!--!**5A!>A*5A*5"8"><<')%
Anti-Tamper Output Default: No Output
5#"#!#
"
Press: 17 # Output #
Output=Output to Activate(0-4)
0=No Output; 2=Auxiliary Relay; 3=Output #3; 4=Output #4;
Changing the 6-Digit Master Programming Code
Press: 98 # Master Code # Master Code #
Master Code=The new 6-digit Master Programming Code
Erasing All Entry Codes
WARNING: PERFORMING THIS COMMAND WILL REMOVE
ALL ENTRY CODES FROM THE MEMORY
Press: 97 # 0 0 0 0 0 0 # 0 0 0 0 0 0 #
Note: The green indicator will light while the memory is being erased. This
may take up to 15 seconds.