Beep Sounds During Auxiliary Relay Default: No
5# !$8
"
Press: 42 # Sound #
Sound=1 for Yes, =0 for No
Beep Sounds During Output #3 Default: No
5# 9:
"
Press: 43 # Sound #
Sound=1 for Yes, =0 for No
Beep Sounds During Output #4 Default: No
5# 9'
"
Press: 44 # Sound #
Sound=1 for Yes, =0 for No
Anti-Pass Back Time Default: No Anti-Pass Back
5#
Press: 51 # Minutes #
Minutes=Time in minutes (2-4), 0=No Anti-passback
RESETTING KEYPAD
Master Reset
CAUTION: Performing a master reset will clear the
entire memory of the 920 and return all programmable
options to the factory default values. ALL ENTRY
CODES WILL BE ERASED. NOTE: The Master Code will
NOT be reset.
STEP 1 /#
STEP 2 )#S9
STEP 3 !#0
#
STEP 4 8##
0
##
Resetting the Master Code
STEP 1 8"#
#
STEP 2 -G8"3O)8
STEP 3 8#J#
#-./#
STEP 4 83O)
D.7!5.8)8K8!77*K>/.5*4<:'%(
Beep Sounds During Main Relay Default: No
5# 78
"
Press: 41 # Sound #
Sound=1 for Yes, =0 for No
Solid-state Output #4 On-time Default: 02 Seconds
59'"#
Press: 24 # Seconds #
Seconds=Output time in seconds (1-60), 99=Toggle Mode
Beep Sounds on Keystrokes Default: Yes
5#
Press: 40 # Sound #
Sound=1 for Yes, =0 for No
)@A*5!--!**5A!>A*5A*5"8"><<')(
Selects mode for Keypad LED Backlight Default: 30 Seconds
5# 660:
#"*
Press: 52 # Output #
0 = Light always OFF
1 = 30 sec light when activated (default)
2 = Light always ON
Solid-state Output #3 On-time Default: 02 Seconds
59:"#
Press: 23 # Seconds #
Seconds=Output time in seconds (1-60), 99=Toggle Mode
Beep Sounds Anti-Tamper Activation Default: No
5# !
#"
Press: 45 # Sound #
Sound=1 for Yes, =0 for No
Changing the Beeper Sound Level
U #"
8"3O)< "
Keypad Lockout Count Default: 3 Attempts
5 #
+,(
Press: 50 # Attempts #
Attempts=Number of attempts before lockout (2-7)
*Refer to Option 13 to Enable Lockout Relay
Door Ajar Timer Default: 60 Seconds
5
;/8!O!8#"
$
Press: 25 # Seconds #
Seconds=Held open time in seconds (1-60)
To Next Page
Loading...