P:\INST INSTRUCTIONS\ELECTRIFIED LOCKSETS\INST-Z7700 REV F 04-24 Page 1
Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email engineer@sdcsecurity.com
Z7750 & Z7752 SERIES
MOTORIZED LATCH RETRACTION & SOLENOID
CONTROLLED MORTISE LOCK
SECURITY DOOR CONTROLS ■ WWW.SDCSECURITY.COM
[t] 800.413.8783 ■ 805.494.0622 ■ E-mail: service@sdcsecurity.com ■ 801 Avenida Acaso, Camarillo, CA 93012 ■ PO Box 3670, Camarillo, CA 93011
INSTALLATION INSTRUCTIONS
A. Door Preparation:
1. Measure desired height from finished floor and mark a horizontal line on door face and door edge.
2. Place template on edge of door as shown and align lever centerline with marked height line on door. Check the
chart for drilling trim holes on template and only mark holes for lock function being installed.
of Cylinder
of Lockcase
of Lever
(rose trim mounting
holes shown)
Vertical Centerline
Installation Template
C
L
C
L
C
L
of Door Edge
C
L
Height line
C
L
of Lever
Door Edge
Door Face
3/8"
2X 12-24 WMS
5-5/8"
1-1/4”
(1-3/4” Deep)
3/8”
2-1/4”
1-1/2”
(1-3/4” Deep)
*
WOOD DOOR
2X 1" Holes
4-3/4" Deep
NOTCH OPENING FOR MOTOR
ON WOOD DOORS ONLY
*
To Next Page
Need help?
General