OS2 Manual Control Points
Technical information and operating instructions
SEC_4296
v1 07.21
+44 (0)1543 443060
sales@secontrols.com
www.secontrols.com
Please keep these operating instructions for future reference and maintenance.
Subject to technical modications. Diagram is not binding.
Product Description.
The OS2 Manual Control Point provides indication of the OS2 SHEVTEC Controller condition
and provides high priority open and close controls.
There are two product variants:
Standard MCP.
Has two push buttons protected from accidental operation by a plastic hinged cover. Once
the cover is lifted an electronic key is required to secure the cover and reset the ashing
green LED.
Tamper-proof MCP.
Used a special electronic key inserted in the slot in the underside to activate the system.
Both MCPs are mounted on the same OS2 MCP Adapter Plate Assembly.
Only to be installed by competent electricians.
To Next Page
Need help?
General
