SE Electronics Reflexion Filter - Assembling Your Reflexion Filter

Reexion Filter Technical Manual
Assembling Your Reexion Filter
1. Remove the Reexion Filter and stand assembly
unit from the packaging. Please keep the packaging
safe to store the Reexion Filter when not in use, or for
transportation. It is robust, but parts may get damaged
or lost in transit if not packaged properly.
You should have the following parts – Reexion Filter
(curved wall), stand assembly, support rod and spanner
to t support rod.
2. Fix the stand clamp assembly in place on the neck of
your microphone stand a few inches below the point where
the shock mount is usually xed, or on the main vertical
support strut of the stand.
You’ll see the assembly has a metal block with two large
screws and a handle on it (one of the screws has a spring to
help lock the assembly rmly onto the mic stand).
Mic stand booms vary in diameter so you’ll need to
experiment to get the clamp just right, but basically you
need to set the screw with the spring so the two parts of the
clamp sit parallel to each other, and then tighten the clamp
using the larger screw.