The disc is straight but the brake
assembly is not. The front brake
is straight and works. Also the
cable pulls the lever and it hits
the engine. We tried adjusting the
cable with no results.
Try using the large adjustment cylinder... it is
silver... should fix the problem.
I filled gas, pressed the bulb.
Then I keep the thing off and pull
start and it does not start. What
is wrong?
Please be sure that the two tubes from gas tank
installed to the right nipples under the engine. The
right order is that the black one goes on the curved
nipple and the clear goes on the straight.
If it still does not start, pump the primer bulb 10
times and put the choke in the up position and give
it 5-7 quick short pulls. It should start, if not, give
little throttle while pulling rope.
When pull to start engine, it pulls
out but engine does not turn over.
Two or three tries and it engage
and engine
turns over or starts.
There is a problem with starter pawl. If your
scooter is still under the warranty, contact the
distributor for the replacement parts.
What kind of maintenances
should I perform on my scooter?
There is one maintenance check which is very
important. Make sure all of the bolts are
tightened before you go out riding. These
scooters vibrate quite a bit, which causes the bolts
to come loose. Specifically, check the front axel
bots, the engine mounts (located right beneath the
engine), the gas tank screws, the front fender screw
(if your scooter has a front fender), and the deck
screws. Also make sure the handlebar folding
mechanism is good and tight. You should also oil
the chain once in a while (not very often). 3-in-1
oil works great for that.
What are the two tubes coming
from the gas tank to the
carburetor?
There are two tubes: one from the tank to the
carburetor and one going the other way.
The clear tube is the fuel return; The black tube is
the fuel supply. The black one goes on the curved
nipple and the clear goes on the straight one.
What kind of gas do I need to put
in a gas powered scooter?
32 to 1 is the ratio recommended.
Doesn't matter what kinds of unleaded gas but
make sure you use two-stroke oil?
Does the gas powered scooter
require any lubrication of the
transmission?
The 90 weight gear oil in the transmission should
not need changing for the life of the gas powered
scooter.
9
To Next Page
Loading...
Need help?
General