Sea-doo 2003 XP DI User Manual (English)

Questions and Answers:

D
David HendersonAug 1, 2025
Why my Sea-doo Boat engine will not start?
- K
  Kristen RamirezAug 1, 2025
  If your Sea-doo Boat engine won't start, there are several potential causes: * The safety lanyard may be incorrect; use the one programmed for your watercraft. * A burnt fuse on the MPEM or in the electrical box (battery, starting system, or fuel pump on fuel injection models) could be the issue; check the wiring and replace the fuse. * The battery may be discharged or disconnected; check and recharge it. * Battery connections might be poor; check, clean, and tighten them. * There may be poor or corroded ground contacts (engine, starter, etc.); check, clean, and repair them.
T
Taylor JohnstonAug 11, 2025
How to fix a hard to start Sea-doo 2003 XP DI engine?
- M
  masonjasonAug 11, 2025
  If you're finding it hard to start your Sea-doo Boat engine, consider the following: * If the temperature is too low, the available battery capacity might not be sufficient. Ensure your battery capacity is adequate for cold temperatures. * If there's water in the fuel reservoir or the fuel is contaminated, flush the reservoir and refill it with fresh gas. * Check the spark plug condition if the spark plug is faulty, fouled, or worn out.
L
lisabrownAug 20, 2025
What to do if Sea-doo Boat engine misfires, runs irregularly?
- C
  cortegaAug 21, 2025
  If your Sea-doo Boat engine misfires or runs irregularly, consider these potential causes and solutions: * Check, verify the heat range and gap, and replace fouled, defective, or worn spark plugs. * Inspect the wiring condition and proper grounding of the ignition coil if there's bad ignition coil wiring. * Check, clean, and repair if there is poor engine ground. * If you have a carburetor model, ensure the fuel level is sufficient by checking and refilling if low. * For carburetor models, also check, clean, and adjust if the carburetion is dirty or out of adjustment.