Sea-doo Spark Series User Manual

101
EEvveerryy MMoonntthh iinn SSaalltt oorr DDiirrttyy WWaatteerr
Spray anticorrosion lubricant to metallic components in engine compartment
(every 10 hours in salt water use)
Inspect sacrificial anodes
EEvveerryy YYeeaarr aatt PPrreesseeaassoonn oorr 110000 HHoouurrss ooff OOppeerraattiioonn
((WWhhiicchheevveerr CCoommeess FFiirrsstt))
Inspect sacrificial anode
Check for fault codes
Perform all items indicated in the Pre-Ride Inspection and Post-Operation
Care
Replace engine oil and filter
Inspect engine rubber mounts
Inspect the cooling system (coolant level, hoses and fasteners for leaks)
Visually inspect connection between throttle body and intake manifold
Inspect the air intake for damage on hoses and clamps
Inspect spark plugs and ignition coils
Inspect electrical connections and fastening (ignition system, starting system,
fuel injectors, fuse boxes etc.)
Verify O.T.A.S. operation (if equipped)
Visually inspect impeller and boot
Visually inspect impeller and wear ring for deep scratches, nicks and grooves
Remove impeller cover and inspect for signs of water intrusion
Visually inspect condition of steering cable and connections
Visually inspect reverse gate bushing for excessive play (if equipped)
Inspect fuel cap, filler neck, fuel tank, fuel tank straps, fuel lines and
connections for leaks
Visually inspect area around carbon ring and drive shaft rubber bellows for the
following signs of failure: black carbon dust and water sprays (more frequently
when using PWC in dirty water)
MAINTENANCE SCHEDULE

Sea-doo Spark Series Specifications

General

Displacement	899 cc
Hull Material	Polytec
Model	Spark, Spark Trixx
Engine Type	Rotax 900 ACE
Horsepower	60 hp / 90 hp
Fuel Type	Gasoline
Fuel Capacity	7.9 US gal (30 L)
Seating Capacity	2 or 3
Length	120 inches (305 cm)
Width	46 in (117 cm)