134
OOPPEERRAATTIINNGG MMOODDEESS
Press the MODE button to change the
operating mode.
TTYYPPIICCAALL
TToouurriinngg MMooddee
By default, the watercraft is set to this
riding mode of operation when
started.
It is also called Normal riding mode.
The icon ECO +OFF appears in the
display when this mode is selected.
SSppoorrtt MMooddee
SPORT MODE provides for instant
throttle response but same accelera-
tions than TOURING MODE.
Once activated, SPORT MODE will
remain active until it is deactivated by
the operator, or the engine is shut
down whereby it defaults back to
TOURING MODE.
AAccttiivvaattiinngg SSppoorrtt MMooddee
To activate the Sport mode, press
once on the MODE button while in
DEFAULT riding mode. Once acti-
vated, the SPORT icon will turn ON.
DDeeaaccttiivvaattiinngg SSppoorrtt MMooddee
A single press on MODE button will
take you to the ECO mode.
EECCOO MMooddee
((FFuueell EEccoonnoommyy MMooddee))
ECO mode provides a smoother throt-
tle application and increased fuel
economy.
CCrruuiissee CCoonnttrrooll MMooddee
Cruise control mode is a function of
iTC (intelligent Throttle Control) sys-
tem that allows the operator to set the
desired watercraft speed.
This is useful when cruising for long
distances, operating in limited speed
zones, or towing a tuber, skier or wake
boarder.
Once the speed is set, the operator
can vary the watercraft speed using
the UP/DOWN buttons on the RH
keypad.
As you proceed under a constant
speed setting, keep your attention lev-
el up to maintain good situational
awareness.
Slowing down is a matter of pressing
the DOWN button, or by pulling the
iBR lever in.
If the iBR lever is pulled in for braking,
the cruise control mode is overridden
and ddeeaaccttiivvaatteedd.
Once the iBR lever is released and
the throttle is pulled in to engage for-
ward thrust, the cruise speed needs to
be manually set again.
The speed setting previously set is de-
leted each time the cruise control is
deactivated.
PPrreerreeqquuiissiittee ffoorr CCrruuiissee CCoonnttrrooll
MMooddee AAccttiivvaattiioonn
Cruise Control Mode can be activated
when the watercraft is at idle speed
and up.
The watercraft must be in forward and
must not have torque reduction due to
faults.
To Next Page
Loading...
