Sea-doo SWITCH 16 2024 - Page 137

135
AAccttiivvaattiinngg tthhee CCrruuiissee CCoonnttrrooll MMooddee
1. Make sure the watercraft is in
forward.
2. Press the Cruise Control button on
the left keypad. Immediately re-
lease the throttle lever after press-
ing the button. Otherwise the
cruise control mode will not
activate.
TTYYPPIICCAALL
A beep will be heard to indicate
that the cruise control mode is now
active, and the cruise control mode
indicator will be lit.
TTYYPPIICCAALL
3. Using the UP/DOWN buttons on
the right keypad, adjust the speed.
DDeeaaccttiivvaattiinngg tthhee CCrruuiissee CCoonnttrrooll
MMooddee
To deactivate the cruise control mode,
pull in the iBR lever or the iTC lever.
The cruise control button can also be
pressed.
Deactivation of cruise control mode is
indicated by the cruise control indica-
tor going off.
SSkkii MMooddee ((IIff EEqquuiippppeedd))
Ski mode allows for repeated and pre-
cisely controlled launches, and a set
towing speed, specifically for towing a
skier or wake boarder.
NNOOTTEE:: A GPS signal is required in
order for the ski function to appear in
the cluster. To obtain a suitable GPS
signal, we recommend that you take
the watercraft outside.
RRAAMMPP FFuunnccttiioonn
The RAMP function offers a pre-prog-
rammed setting for launching and ac-
celerating the watercraft.
RAMP 1 provides:
– Slowest launch (smoothest)
– Slowest acceleration rate
RAMP 5 provides:
– Quickest launch
– Quickest acceleration rate
TTAARRGGEETT SSPPEEEEDD FFuunnccttiioonn
The TARGET SPEED function limits
the maximum towing speed.
Once the RAMP has been selected,
an average watercraft target speed for
that RAMP will be visible in the numer-
ical display.
The operator may increase or de-
crease the target speed to any value
within the selected RAMP speed
range.
UUssiinngg SSkkii MMooddee
1. Press MODE button to select the
SKI mode.
2. Press OK button when SKI icon
flashes.
3. Select ski ramp by using the UP or
DOWN arrow button. Ramp 1 will
give the slowest acceleration.
OPERATING MODES