136
NNOOTTEE::
Acceleration ramp will not behave the
same depending on the vehicle type,
vehicle load and water conditions. For
safety reasons, always start using
ramp # 1 to familiarize your skier with
acceleration and then change the
ramp as needed.
4. Press OK or RIGHT arrow button
to confirm acceleration ramp.
5. Select the maximum target speed
by using the UP or DOWN arrow
button.
6. Press OK or RIGHT arrow button
to confirm.
NNOOTTEE::
At any moment you can use the LEFT
and RIGHT arrow buttons to change
the ramp and speed selection.
7. After your selection and when your
are ready, press the OK button to
activate the function.
The message SSKKII RREEAADDYY will
display.
Keep throttle fully applied to ski.
Releasing the throttle or applying the
brake will pause the SKI mode, simply
press OK button to reactivate the SKI
mode.
NNOOTTEE::
MODE remains active and ready until
another driving mode is chosen.
DDeeaaccttiivvaattiinngg SSkkii MMooddee
To end a ski run and completely deac-
tivate ski mode, release the throttle to
idle, then press the MODE button.
OPERATING MODES
To Next Page
Loading...
