87
WWAARRNNIINNGG
IIff tthhee tthhrroottttllee lleevveerr iiss ssttiillll ppuulllleedd iinn
wwhheenn rreelleeaassiinngg tthhee iiBBRR lleevveerr,, ffoorr--
wwaarrdd mmoovveemmeenntt wwiillll bbee iinniittiiaatteedd
aafftteerr aa sshhoorrtt ddeellaayy.. IIff ffoorrwwaarrdd aacc--
cceelleerraattiioonn iiss nnoott ddeessiirreedd,, rreelleeaassee
tthhee tthhrroottttllee lleevveerr..
NNOOTTEE::
The neutral position can be fine tuned
by trimming the iBR system.
Refer to
Operating Instructions
for de-
tailed instructions.
MMaasstteerr SSwwiittcchh
The master switch is located in the en-
gine compartment.
TTYYPPIICCAALL
It is accessible by removing the floor
access panel identified in the following
illustration.
TTYYPPIICCAALL
CClloossiinngg aanndd OOppeenniinngg tthhee MMaasstteerr
SSwwiittcchh
The master switch allows to discon-
nect the battery from the watercraft. It
should be used to safely remove the
battery and for long term storage.
Turning the knob clockwise to ON po-
sition will close the master switch and
supply electrical current from the bat-
tery to the watercraft.
Turning the knob counter-clockwise to
OFF position will open the master
switch and prevent the electrical cur-
rent to flow from the battery to the
watercraft.
RReemmoovviinngg tthhee MMaasstteerr SSwwiittcchh KKnnoobb
The master switch knob can also be
removed to prevent unauthorized use
of the vehicle.
To remove the master switch knob,
turn the knob counter-clockwise from
the OFF position.
To install, insert the knob in place and
turn clockwise to reach the OFF
position.
NNOOTTEE:: Be careful to not drop the
knob in the engine compartment when
removing or installing the master
switch knob.
EEnnggiinnee CCuutt--OOffff SSwwiittcchh
The engine cut-off switch is located on
the RH side of the console.
PRIMARY CONTROLS
To Next Page
Loading...
