89
Press the START/STOP button once
without installing the tether cord on
the engine cut-off switch.
This will power up the electrical sys-
tem; the information center will cycle
through a self-test function.
The electrical system will stay pow-
ered up for approximately 75 seconds
after the START/STOP button was
depressed.
When the tether cord is installed on
the engine cut-off switch, the system
will be powered for 60 minutes.
Every time the START/STOP button is
pressed, the countdown restarts.
When the battery voltage drops below
12.3V, the LOW BATTERY indicator
lamp will light up and the electrical
system will shut down after 75
seconds.
PPoosstt--DDrriivvee BBaatttteerryy MMaannaaggeemmeenntt ((IIff
eeqquuiippppeedd))
This feature keeps the electrical sys-
tem awake to allow using accessories
when the engine is turned off. It also
prevents draining the battery too
much when using accessories. When
the battery voltage reaches 12.3V or
less, the system will automatically
shut down to ensure enough power
remains to start the engine.
When the electrical system is acti-
vated by pressing START/STOP
briefly while the engine is shut down
the wake-up time will be managed as
follows:
– Key off: System will shut down
after 75 seconds.
– Key on: System will shut down
after 60 minutes or if the voltage
threshold is reached.
PRIMARY CONTROLS
To Next Page
Loading...
