90
SSEECCOONNDDAARRYY CCOONNTTRROOLLSS
RRiigghhtt CCoonnttrroolllleerr
The right controller is located on the
RH side of the handlebar.
RRIIGGHHTT CCOONNTTRROOLLLLEERR
The right controller includes controls
to navigate in the multifunction gauge.
– Arrow UP
– Arrow RH
– Arrow Down
– Arrow LH
– OK button.
In Cruise Control Mode, UP and
DOWN arrows will increase and de-
crease the cruising speed.
LLeefftt CCoonnttrroolllleerr
The left controller is located on the LH
side of the handlebar.
LLEEFFTT CCOONNTTRROOLLLLEERR
VVaarriiaabbllee TTrriimm SSyysstteemm ((VVTTSS)) BBuuttttoonn
The VTS button provides watercraft
pitch trim adjustments by adjusting the
vertical position of the jet nozzle.
The VTS can be electrically trimmed
to desired attitude, or to one of tree
preset trim positions (full up, middle
and full down).
Refer to
Operating Instructions
for
details.
NNOOTTEE::
The VTS button is used for Neutral ad-
justment. This is to adjust the neutral
position of the watercraft. Refer to
Op-
erating Modes
for details
1. Bow up
2. Bow down
CCrruuiissee CCoonnttrrooll BBuuttttoonn
TTYYPPIICCAALL
Allow to set a cruising speed.
To Next Page
Loading...
