9
Sea Eagle Boats Inc. 19 N. Columbia Street, Ste1, Port Jefferson, NY 11777 • 1-800-748-8066 • Staff@SeaEagle.com
EZLite™ Kayaks | DEFLATION
Slide folded boat (approx.
35”x17”x6”) and accesso-
ries into the backpack bag.
Begin folding boat from
the bow (end opposite the
valves). Make a crease just
behind the front carry
handle.
Continue folding toward the
valves, pushing air out as
you go.
Fold boat all the way to the
end, the rear carry handle
should be covered by the
folded boat. Press out any
remaining air.
Then, unfold two folds. Fold
the back towards the front
twice. Place the large folded
portion on top of the rear
portion. This will place the
skeg base in a flat position,
which will keep the base
from getting warped.
Boat, paddles, seat,
FlexBrace pedals, skeg,
repair kit and pump will
fit in the bag. Packed out
bag weighs approximately
38 lbs.
EZLite™ Kayaks | CLEANING & PROTECTING
Dry after each use to avoid mold. While washing or
rinsing: close the valve and twist the cap on so water
cannot not enter the chamber. Sea Eagles can be cleaned
very effectively with general purpose cleaning products and a
scrub brush. Towel dry.
Protection from the Sun and Heat
Avoid leaving the boat in direct sunlight when ashore.
Temperatures on a beach, dock, davit, etc. can get very high,
which could affect the vinyl or glue. Excessive exposure to sun
and heat can cause your Sea Eagle to become sticky or cause
the glue to fail.
Treat the boat with a UV protectant such as 303 Aerospace
Protectant. Generally, protectants are a thin film of oil, which
will help keep your Sea Eagle clean. Avoid applying protectant
on the EVA pad or places where foot traction is needed. Treated
boat will repel sand, water scum and tar stains.
To Next Page
Loading...