9
FastCat14.4| SETUP: TOOLS FOR 1 TIME ASSEMBLY
Tools for One-Time
Assembly
#2 Phillips head screw-
driver and two wrenches.
Can use 7/16” wrench and
adjustable wrench or two
adjustable wrenches. An
wrench is recommended
for tightening transom
bolts before each use.
Inflate:
Press and turn the stem
counterclockwise so it can
pop UP. When the stem is
up, the valve is closed and
will hold air.
Deflate:
To let air escape for
deflation, press and turn
the stem clockwise until
locked open.
Screw the hose onto the
pump.
Begin In the double action
mode for fast fill.
Switch to single action
when handle becomes too
hard to lift.
FastCat14.4 | ASSEMBLY & INFLATION
Inflate Floor Only
With valve stem in the up
position, insert adapter,
push down firmly and twist
clockwise.
Having trouble inserting
the adapter? See
troubleshooting on page
15-16.
Caution: Do not drag
boat while it is rolled up.
Dragging on abrasive sur-
face will damage boat, pos-
sibly causing multiple holes.
Locate area large enough
to safely unfold the Fast-
Cat14.4. Check that the area
is free of hazards that could
injure you or damage the
boat.
The pump hose has a
Recessed Valve Adapter
at one end. When ready
to inflate the boat, push
adapter firmly into valve
and twist clockwise to lock
in.
Using the Recessed
Valves:
Remove the cap to access
the valve stem.
Note: Maximum pressure is
15 psi (pounds per square
inch), working pressure is
13-14.5 psi.
Using the Double Action
Hand Pump:
In the double action mode
the pump inflates on the
up and down strokes. In
the single action mode,
the handle comes up more
easily, allowing the user
to push hard on the down
stroke.
To Next Page
Loading...