15
FastCat14.4 | ASSEMBLY & INFLATION
Scotty® Deck Mounts
(OPTIONAL):
Attach deck mounts with
the provided 7/8” phil cap
screws to the pad mounts
near the transom.
Screws are located in
a Scotty Hardware Bag.
Arrow on the base points
inboard.
Don’t stab the pad!
Use only ¼ - 20 x 7/8”
screws provided. Longer
screws, pointed screws,
etc., will puncture the air
chamber.
Puncturing the air chamber
in this manner is not covered
under the warranty.
Caution: Puncture hazard: do not thread screws into base
without the Scotty Deck Mount.
To install a Scotty accessory
in the mount, push stem into
base until it clicks in. Large
knob on side of Rod Holder is
for adjusting rod angle.
Shown here is the Scotty®
Baitcaster Rod Holder.
Anchor Lock mount does not
have button, it works by lining
up a groove in the stem with a
raised key in the base. Lift
partially and turn Anchor Lock
to swing anchor overboard.
FastCat14.4 | DEFLATION
Remove transom, seat
frames, rod holders and
canopy. Rod holder bases
can remain in place in boat.
Place the boat bag under
front of boat.
To deflate, push down on
the valve stem and quarter
turn it to the right or left.
The stem will stay in the
down position, allowing the
air to escape.
Caution: Air escapes
with force, do not place
face directly over valve.
Place boat bag under the
bow. Line up bottom panel
of boat bag with front edge
of the boat.
Canopy can be folded
towards the front of the
boat.
To Next Page
Loading...