16
FastCat14.4 | DEFLATION
End caps will be centered
on bow handles. At the
back of the boat, the side
motor mount grommets
will be touching the inner
motor mount grommets.
Keep folding and make
adjustments so the folds do
not begin to drift off to one
side.
Begin folding by putting
a crease between the rear
handle and D-ring. Fold the
back of the boat forward.
Once the final fold is
reached, the boat will be in
position to begin securing
the boat bag.
Secure the side flaps with
straps.
Secure end flaps with
straps. Strap goes through
both loops then back
through one loop.
FastCat14.4 | CLEANING & PROTECTING
Dry after each use to avoid mold. While washing or
rinsing: close the valve and twist the cap on so water
cannot not enter the chamber. Sea Eagles can be cleaned
very effectively with general purpose cleaning products and a
scrub brush. Towel dry.
Continued next page...
Push the side chambers
inward. The boat can be
folded without adjusting
the width, but the final di-
mensions will be
approximately 82” x 23 x
15. For a more compact
fold (72”x 29 x 15), use an 8’
strap to pull the bow
handles together until
there is about 30” between
the side chambers.
To Next Page
Loading...