Need help?Do you have a question about the Sea Ray's 400 Sedan bridge and is the answer not in the manual?
General| Deadrise | 18 degrees |
|---|---|
| Sleeping Capacity | 6 |
| Draft | 3' 4" |
| Weight | 22, 000 lbs |
| Fuel Capacity | 350 gallons |
| Engines | Twin Cummins QSB 6.7 |
| Length Overall | 40 ft 0 in |
| Horsepower | 380 hp (283 kW) each (MerCruiser) or 380 hp (283 kW) each (Cummins) |
Details on the automatic bilge pump system and its components.
Information on the inboard drive type propulsion system.
Information regarding gasoline or diesel fuel systems.
Description of the exhaust system as part of the propulsion system.
Details on the engine cooling system as part of the propulsion system.
Information on boat electrical schematics and recommendations for service.
Information on battery disconnect, maintenance, and specifications.
Information on bilge blowers for fume removal and ventilation.
Details on the boat's hydraulic steering system.
Information about the automatic fire extinguishing system.
Procedure for anchoring the vessel into wind or current.
Description of the windlass and anchor chute system.
Details on the optional electrically driven bow thruster system.
Information on PFD storage, operation, and maintenance.
Procedures for wet storage and preventing marine growth.
Recommendations for securing the boat and its contents.
References for performance, engine, and electrical issues.
Diagram and labels for the bridge control station.
Diagram and labels for the bridge gauge panel.
Diagram and labels for the bridge switch panel.
Diagram and labels for the bridge breaker panel.
Diagram and labels for the lower control station.
Diagram and labels for the lower gauge panel.
Diagram and labels for the lower switch panel.
Diagram and labels for the lower breaker panel.
Identification of various bilge components shown on the diagram.
Diagram showing through-hull fittings on the port side.
Diagram showing through-hull fittings on the starboard side.
Diagram illustrating bilge hull cutouts.
Information on the simplified generator starting module.
Details on starting, stopping, and bypassing the Westerbeke generator.
Part 1 of 4 of the DC wiring schematic.
Part 2 of 4 of the DC wiring schematic.
Part 3 of 4 of the DC wiring schematic.
Part 4 of 4 of the DC wiring schematic.
Part 1 of 2 of the DC wiring schematic for diesel engines.
Part 2 of 2 of the DC wiring schematic for diesel engines.
Part 1 of 2 of the cabin DC wiring schematic.
Part 2 of 2 of the cabin DC wiring schematic.
Wiring configuration for 120V 60Hz Westerbeke generator.
Wiring configuration for 220V 50Hz Westerbeke generator.
Wiring configuration for 240V 60Hz Westerbeke generator.
To Next Page