U Series 5 Family Product Manual, Rev. B 31
SeaTools diagnostic software activates a built-in drive self-test (DST)
S.M.A.R.T. command for D4
H
that eliminates unnecessary drive returns.
The diagnostic software ships with all new drives and is also available at:
www.seagate.com/support/npf/seatools/seatool-entry.shtml
This drive is shipped with S.M.A.R.T. features disabled. You must have
a recent BIOS or software package that supports S.M.A.R.T. to enable
this feature. The table below shows the S.M.A.R.T. command codes that
the drive uses.
Note. If an appropriate code is not written to the Features Register, the
command is aborted and 0x04 (abort) is written to the Error
register.
Code in Features
Register
S.M.A.R.T. Command
D0
H
S.M.A.R.T. Read Data
D1
H
Obsolete
D2
H
S.M.A.R.T. Enable/Disable Attribute Autosave
D3
H
S.M.A.R.T. Save Attribute Values
D4
H
S.M.A.R.T. Execute Off-line Immediate
(runs DST)
D5
H
S.M.A.R.T. Read Log Sector
D6
H
S.M.A.R.T. Write Log Sector
D7
H
Obsolete
D8
H
S.M.A.R.T. Enable Operations
D9
H
S.M.A.R.T. Disable Operations
DA
H
S.M.A.R.T. Return Status
To Next Page
Loading...
