Seagull IV X-1F - User Manual

To Next Page

SEAGULL

IV X-1F

Drinking Water Purification System

NOTE: Read instructions completely before starting.

General Ecology’s X-1F drinking water purification system is designed to operate at pressures ranging from 25 to 125 psi. If pressure

surges are a possibility (municipal water supplies), install a Pressure Regulator or Surge Protector on the cold water supply line. This

system is intended to be installed to the cold water supply line, downstream of and above the cold water shut-off valve inside the

kitchen sink cabinet (see page 4). Be sure to close supply valves before installation. The Connector Hose will fit an Owner-Supplied

Connector T or our optional Saddle T Assembly or Male Run T shown on page 4. Connector branch of Owner Supplied T must have

" Male Compression Thread (

" - 24 Thread). The cold water supply line should be clean and free of construction debris. A

" to

1½" diameter hole is necessary for mounting the easily installed special Faucet furnished with this unit.

Follow steps 1 through 9 for installation. Steps A through F are cartridge replacement instructions. An order blank is included for

assistance in obtaining replacement Cartridges. Configuration specifications are shown at the end of this guide.

Installation Instructions

INSTALLATION AND PRODUCT USE GUIDE

supersedes 200712Ax-1f-i&o

Need help?

Do you have a question about the Seagull IV X-1F and is the answer not in the manual?

Seagull IV X-1F Specifications

General