Seakeeper 6 - Page 44


INSTALLATION
MANUAL
Product: Document #: Rev: Page:
SEAKEEPER 5 90402 1 3 of 4
Section 5: INSTALLATION CHECKLIST AND SUPPLIES


5.1 Required Supplies needed for Seakeeper Installation (not
supplied with Seakeeper)
Item Description Qty
Installation
Manual
Reference
Section
Other
Reference
System
1 Adhesive and cleaning supplies for bonding to
hull
1 Mechanical
2 Soundproofing Considerations 1 Mechanical
3 Spreader bar for lifting Seakeeper 1 Mechanical
4 Hose clamps for seawater plumbing to 3/4" (19
mm) hose barb (2 per hose barb)
4 3 Cooling
5 Circuit Breaker, AC, 2-Pole, (25 Amp to be used
with 110-115 VAC, 20 Amp to be used with 208-
230 VAC)
1 2.2.2 Dwg 90396 Electrical
6 Circuit Breaker, AC, 2-Pole, 5 Amp 1 2.2.3 Dwg 90396 Electrical
7 Circuit Breaker, DC, 1-Pole, 15 Amp 1 2.2.4-5 Dwg 90396 Electrical
8 M6 terminal lug for grounding Seakeeper at rear
brace
1 2.3.1 Electrical
9 Cable, 10AWG, for grounding Seakeeper at rear
brace to vessel ground (used with item 6)
AR 2.3.1 Dwg 90396 Electrical
10 Sea water pump, 110-230V AC 1 2.2.3 Electrical
11 Relay for sea water pump control (Not required
if using Seakeepe
r
output 110-230V AC pump)
1 2.2.3 Electrical
AR = As Required
Dwg = Drawing