Plug in the Starboard Actuator so that both Cables are plugged into the Distribution Module.
Note: Follow installation wizard to congure Starboard Controller.
Diagnostics
WARNING: Diagnostic’s functions do not observe vessel
speed, DO NOT attempt to perform Diagnostics when
vessel is moving!!
Note: Vessel must be stopped when performing Diagnostics.
Diagnostics tests the mechanical travel, direction of motion, and communication of the Seakeeper
Ride system prior to sea trialing. Please pay attention to which Controller side (Port or Starboard) you
are diagnosing, so the movement of the controller matches the indicated movement on the Ride
App Screen
Note: Diagnostics will be completed twice to check that both Actuators are functioning correctly. If
your system has a keypad, the lights will not function during Diagnostics.
To Next Page
Loading...
