Seakeeper Ride User Manual (English)

To Next Page

Seakeeper Ride | Commissioning Instructions

1. Introduction

Updated 10/25/2023

Following installation, the Seakeeper Ride system must be congured prior to operation. This process

is performed by the Original Equipment Manufacturer (OEM/boat builder) or a professional

Seakeeper certied installer if they performed the installation.

Note: Scan the QR code below to access Seakeeper Ride BILT 3D instructions. BILT App will assist in

familiarization with the Seakeeper Ride components and includes a specic section for

commissioning.

ATTENTION! Changing these critical settings can render the system non-functional and create an

unsafe operating condition. Please proceed only if you have read and understand this manual in full.

6/21/24, 9:02 AM

Seakeeper Ride | Commissioning Instructions – Seakeeper Manuals

https://manuals.seakeeper.com/ride/seakeeper-ride-commissioning-instructions/?print=true

1/41

Need help?

Do you have a question about the Seakeeper Ride and is the answer not in the manual?

Seakeeper Ride Specifications

General

Type	Stabilization System
Installation	Professional installation required
Control	Automatic with manual override
Power Supply	12V or 24V DC
Warranty	2 years

Selects the orientation of the software module relative to the boat's bow or stern.

Configures the port side controller's cable routing and connection.

Tests the port controller's ability to retract and deploy its blade.

Calibrates the zero position for the port controller blade.

Adjusts system sensors to match the detected horizon for target attitude.

Programs the system to understand the IMU's relation to the boat.