Controller Zeroing
When Seakeeper Ride is at rest, the Blade will be up not interrupting water ow behind the seal
plate. As the
control system dictates, the Blade rotates down and it creates lift at the transom stabilizing the boat.
Controller Zeroing calibrates the position of the Blade relative to the Seal Plate. Changing this setting
can render the system nonfunctional and create an unsafe operating condition. Before proceeding,
please review the Operation Manual for proper procedure and requirements.
ATTENTION! Because of the risk associated with these procedures
there is a pass code which must be used when accessing these
pages. The pass code is 339037.
To Next Page
Loading...
