Seakeeper Ride - Advanced Mode Configuration

5. Enter Advanced Mode
The following instructions for ‘Advanced Mode’ will remain available for users that have
updated theirSeakeeperRide system prior to September 1, 2023. Please update Seakeeper Ride
system to the latest Software Update possible at the link listed
here.https://ride.seakeeper.com/support/software-updates/
Access Advanced Mode to congure the system components. Conguration will program all
components to function together as a complete system. This step must be performed on the rst
start of the Seakeeper Ride System to make the system operational. Only under extenuating
circumstances will the Advanced Mode need to be accessed following the rst start. The operator
will be able to access conguration settings for:
Angle Calibration
IMU Orientation
Controller Conguration
ATTENTION! The Advanced Mode screen is only to be used when commissioning the Seakeeper
Ride system or if conguration was done incorrectly.
1.
From the Home screen press Settings in the bottom right of the MFD.
2.
Select the Install screen in the top right.
3.
Select Advanced Mode.
4. You will be prompted twice to determine if you wish to proceed. Select Continue both times
to access the conguration home screen.
6/21/24, 9:02 AM
Seakeeper Ride | Commissioning Instructions – Seakeeper Manuals
https://manuals.seakeeper.com/ride/seakeeper-ride-commissioning-instructions/?print=true
27/41