Once you initiate the ‘Factory Reset’ you will follow procedure shown in (SeakeeperRide |
Commissioning Instructions- Section 3) to restore Seakeeper Ride functionality.
Note:The speed of the boat, GPS connection, and the system
being in Auto or Manual mode will all inuence
howSeakeeperRide behaves. Even ifSeakeeperRide is set up
correctly, the Controllers may have limited range based on
these factors. Refer to the table below for more information
and see theSeakeeperRide Operation ManualSection
2.1andSection 2.2for home screen controls.
If theSeakeeperRide system has not been commissioned previously, then please follow the
Section 3 –First InstallationCommissioning steps.
To Next Page
Loading...
