WARNING: DO NOT UTILIZE THE FACTORY RESET IF FAULT CODES
ARE PRESENT!
WARNING: Please be aware a factory reset will result in the
Seakeeper Ride equipment not functioning until a full
commissioning is completed again.
The Seakeeper Ride Factory Reset feature will wipe the entire Ride system and restore it to factory
default settings. By pressing ‘RESET’, the system will restart, and a full reinstallation procedure will be
required. This procedure will require access to the Software Module, Distribution Module, knowledge
of the cable corresponding to each Controller and the Blades and Seal Plates.
ATTENTION! Because of the risk associated with these procedures
there is a pass code which must be used when accessing these pages.
The pass code is 339037.
To Next Page
Loading...
