EasyManua.ls Logo

Sealey ELECTROSTART E/START1600.V2 - User Manual

Sealey ELECTROSTART E/START1600.V2
4 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
1. SAFETY
INSTRUCTIONS FOR:
ELECTROSTART® BATTERYLESS POWER
START 1600A 12V
MODEL NO: E/START1600.V2
Wear
Protective
Gloves
Warning:
Electricity
Protect
From
Rain
Use in
Well
Ventilated
Areas
Keep away
from sources
of ignition:
Battery could
explode
Warning:
Explosive
Material
Wear eye
Protection
Warning:
Corrosive
substance
Refer to
Instruction
Manual
Modern vehicles contain extensive electronic systems.
YouarerequiredtocheckwiththevehicleManufacturer,foranyspecicinstructionsregardingtheuseofthistypeof
equipment on each vehicle. No liability will be accepted for damage / injury, where this product is not used in accordance
with all instructions.
9 Ensure that the vehicle is in a well ventilated area.
9 Apply the handbrake and select neutral or ‘park’ before attempting to start.
9 Ensure that the ignition switch and all ancillary electrical equipment is switched off.
9 Keep clear of any pulleys, belts etc. that will move once the engine starts.
9 Take care to ensure correct connection polarity; red clamp to positive, black clamp to negative.
9 Energise the E/START1600.V2 only at ambient temperatures between -30°C and 40°C.
9 When not in use, switch off and store in a cool, dry place out of the reach of children.
8 DO NOT allow this power pack to become wet.
8 DO NOT dismantle this E/START1600.V2: there are no user serviceable parts inside.
8 DO NOT use in explosive atmospheres (e.g. the presence of flammable liquids, gases or dust).
8 DO NOT use the E/START1600.V2 if it appears damaged in any way.
8 DO NOT use this product for any purpose other than that for which it is designed.
8 DO NOT leave in direct sunlight or expose to heat.
8 DO NOT use abrasive or solvent cleaners on this product.
8 DO NOT allow children to play with this product
8 DO NOT allow the positive and negative clamps to touch.
1.1. CHARGING SAFETY INSTRUCTIONS
9 Familiarise yourself with the application and limitations of the charger as well as the potential hazards. Also refer to the vehicle
manufacturer’s hand book. IF IN ANY DOUBT CONSULT A QUALIFIED ELECTRICIAN.
9 Ensure the charger is in good condition before use. If in any doubt do not use the unit, contact your Sealey stockist.
9 Use the starter/charger in the upright position only and ensure it is placed on a stable surface which will adequately support its weight.
9 Keep tools and other items away from the engine and ensure you can see the battery and working parts of engine clearly.
9 Ensure the output of the charger is the same voltage as the battery.
9 Ensure that during charging, the charger is placed in a location where there is sufficient ventilation to prevent the build up of explosive
gases from a lead acid battery.
9 If battery has caps to access the battery fluid, remove the caps and check the fluid level before connecting the power clamps.
9 If necessary top-up the battery with distilled water by referring to the battery manufacturer’s instructions.. If the charger receives a sharp
knock or blow the unit must be checked by a qualified service agent before using.
9 If the battery terminals are corroded or dirty clean them before attaching the power clamps.
9 Keep children and unauthorised persons away from the working area.
8 DO NOT try to charge a non-rechargeable battery.
8 DO NOT try to charge battery if battery fluid is frozen.
WARNING! To prevent the risk of sparking, short circuit and possible explosion DO NOT drop metal tools in the battery area, or allow
them to touch the battery terminals.
8 DO NOT allow power clamps to touch each other or to make contact with any metallic part of the vehicle.
8 DO NOT cross connect power leads from charger to battery. Ensure positive (+/RED) is to positive and negative (-/BLACK) is to negative.
8 DO NOT pull the cables or clamps from the battery terminals.
8 DO NOT use the charger outdoors, or in damp, or wet locations and DO NOT operate within the vicinity of flammable liquids or gases.
8 DO NOT use the charger for a task for which it is not designed.
WARNING! DO NOT simultaneously charge batteries of different capacities or discharge levels.
WARNING! If a fuse blows, ensure it is replaced with an identical fuse type and rating. Use only Sealey genuine parts.
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
E/START1600.V2 Issue: 1 - 12/10/17
Original Language Version
© Jack Sealey Limited
E/START1600.V2 Issue: 1 - 12/10/17
Original Language Version
© Jack Sealey Limited
Question and Answer IconNeed help?

Do you have a question about the Sealey ELECTROSTART E/START1600.V2 and is the answer not in the manual?

Sealey ELECTROSTART E/START1600.V2 Specifications

General IconGeneral
BrandSealey
ModelELECTROSTART E/START1600.V2
CategoryBattery Charger
LanguageEnglish

Related product manuals