EasyManua.ls Logo

Sears 536.79751 - Engine Storage; Storage

Sears 536.79751
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
STORAGE
[ _ILJJJJ J ii_JJJl _ _J _IJ-_JJLWII_LIL
CAUTION: NEVER STORE YOUR
EDGER INDOORS OR IN AN EN-
CLOSED, POORLY VENTILATED AREA
IF GASOLINE REMAINS IN THE TANK. FUMES
MAY REACH AN OPEN FLAME_ SPARK OR PI"
LOT LIGHT FROM A FURNACE, WATER HEATER,
CLOTHES DRYER, CIGARETTE, ETC.
iii L Jii JLui,,_Jil_
To prevent engine damage ( if edger is not used for more
than 30 days) follow the steps below°
ENGINE STORAGE
Gasoline must be removed or treated to prevent gum
deposits from forming In the tank, fitter, hose, and
carburetor during storage. Also during storage, al-
cohol blended gasoline that uses ethanol or metha-
nol (sometimes called gasohol) attracts water. It acts
on the gasoline to form acids which damage the
engine.
You can keep your engine In good operating condi-
tion during storage by:
Changing oil.
Lubricating the piston/cylinder area. This can be
done by first removing the spark plug and squirting
clean engine oil into the spark plug hole Then cover
the spark plug hQte with a rag to absorb oil spray_
Next, rotate the engine by pulling the starter two or
three times_ Finally, reinstall spark plug and attach
spark plug wire_
EDGER STORAGE
o To remove gasoline, run the engine until the tank is
empty and the engine stops.
If you do not want to remove gasoline, a fuel
stabilizer (such as Sears Craftsman fuel stabilizer
No..33500) may be added to any gasoline Iett in the
tank to minimize gum deposits and acids_ If the tank
is almost empty, mix stablilizer with fresh gasoline
in a separate container and add some to the tank.
ALWAYS FOLLOW INSTRUCTIOHS ON STABI-
LIZER CONTAINER. THEN RUN ENGINE AT
LEAST 10 MINUTES AFTER STABILIZER IS
ADDED TO ALLOW MIXTURE TO REACH CAR-
BURETOR. STORE EDGER IN A SAFE PLACE.
SEE WARNING ABOVE.
Store the edger in the wheels-down, operating
position. If the edger is stored in any other position,
oil from the crankcase could enter the cylinder,
causing a service problem_
Clean lhe edger thoroughly; remove all debris and
wipe the unit dry.
Inspect the edger for worn or damaged parts and
tighten all loose hardware
Oil all points described in the Lubrication para-
graph in the Maintenance section of this manual
Store the edger in a protected area and cover for
additional protection
IMPORTANT:
A YEARLY CHECKUP OR TUNEUP BY
A SEARS SERVICE CENTER tS A
GOOD WAY OF INSURING THAT
YOUR EDGER WILL PROVIDE
MAXIMUM PERFORMANCE FOR
THE NEXT SEASON.
f
L
\
16