Sears CRAFTSMAN 165.155250

Questions and Answers

K
Katherine TuckerAug 9, 2025
What to do if my Sears CRAFTSMAN 165.155250 Paint Sprayer motor operates but there is no spray?
- D
  Daniel SmithAug 9, 2025
  If your Sears Paint Sprayer's motor is running but no paint is coming out, there are several possible causes. First, check the suction tube to ensure it is tightened and undamaged; tighten or replace if necessary. Make sure the suction tube is correctly placed in the front hole, not the drainage hole. Also, the vent hole or the nozzle/spray valve might be plugged, so try cleaning them thoroughly.
C
collinwallaceAug 16, 2025
Why is my Sears CRAFTSMAN 165.155250 spitting or globbing paint?
- B
  blopezAug 16, 2025
  If your Sears Paint Sprayer is spitting or globbing paint, it could be due to several reasons. You might be low on paint, so refill the container. Ensure you're holding the sprayer horizontally to keep the suction tube submerged in paint. Also, check that the suction tube is firmly inserted in the front hole to prevent air from being drawn in. Finally, a worn or wrong-sized nozzle or a worn spray valve could be the culprit, so consider replacing them.
C
Crystal Miller MDAug 22, 2025
What to do if Sears Paint Sprayer motor hums but there is no spray?
- D
  Diana NelsonAug 22, 2025
  If your Sears Paint Sprayer motor hums but no paint sprays, the issue could stem from a few potential problems. A loose leaf spring might be the cause; remove the cover and reattach the leaf spring, ensuring the side without the hole faces up. Alternatively, the piston might be frozen, requiring you to disassemble and clean the gun.
C
Chad JordanAug 27, 2025
How to fix excessive fogging with Sears CRAFTSMAN 165.155250?
- S
  scottliuAug 27, 2025
  Excessive fogging with your Sears Paint Sprayer can occur for several reasons. It could be because you're holding the sprayer too far from the surface. Another cause might be that the nozzle is too large for the paint you're using, or the nozzle is worn; try using a new nozzle. Also, the material might be thinned too much; ensure you thin it properly.
J
James MackSep 2, 2025
Why does my Sears CRAFTSMAN 165.155250 cause runs and sags in paint?
- T
  Terry HornSep 2, 2025
  Runs and sags in the paint when using your Sears Paint Sprayer can be attributed to a few factors. Your arm movement might be too slow. You might be holding the sprayer too close to the surface or applying too much paint at once. The nozzle could be too large; use the correct nozzle. Finally, the material might be thinned too much; thin it properly.