To Next PageTo Next Page
Need help?Do you have a question about the Sears CRAFTSMAN 720.3263 and is the answer not in the manual?
Cuts grooves from 3/16" to 13/16" wide with a maximum depth of 1-1/2".
Cuts grooves from 1/4" to 13/16" wide with a maximum depth of 2".
Do not operate at speed greater than 4500 rpm.
Use proper guard for radial saw operations and adjust correctly.
Ensure a dado insert is properly installed and adjusted on a table saw.
Handle warped workpieces correctly and avoid kickbacks.
Do not cut through the workpiece entirely or cut stone, masonry, or metal.
Provide adequate hold down and use pushsticks for safety.
Avoid using both miter gage and rip fence simultaneously.
Mount dado like a circular saw blade; remove spreader, use bushing if needed.
Tighten arbor nut after setting desired width and checking clearance.
Adjust outer hub for desired width, check clearance by hand rotation.
Read manual, learn applications, limitations, and potential hazards.
Ensure proper grounding and never connect green wire to live terminal.
Keep guards in place and remove all adjusting keys before operation.
Keep work area clean, well-lit, and avoid damp or wet locations.
Wear safety goggles, proper apparel, and maintain good footing.
Use the right tool, don't force it, maintain tools with care.
Ensure switch is 'OFF' before plugging in and disconnect for servicing.
Use recommended accessories and check for damaged parts before use.
Cuts grooves from 3/16" to 13/16" wide with a maximum depth of 1-1/2".
Cuts grooves from 1/4" to 13/16" wide with a maximum depth of 2".
Do not operate at speed greater than 4500 rpm.
Use proper guard for radial saw operations and adjust correctly.
Ensure a dado insert is properly installed and adjusted on a table saw.
Handle warped workpieces correctly and avoid kickbacks.
Do not cut through the workpiece entirely or cut stone, masonry, or metal.
Provide adequate hold down and use pushsticks for safety.
Avoid using both miter gage and rip fence simultaneously.
Mount dado like a circular saw blade; remove spreader, use bushing if needed.
Tighten arbor nut after setting desired width and checking clearance.
Adjust outer hub for desired width, check clearance by hand rotation.
Read manual, learn applications, limitations, and potential hazards.
Ensure proper grounding and never connect green wire to live terminal.
Keep guards in place and remove all adjusting keys before operation.
Keep work area clean, well-lit, and avoid damp or wet locations.
Wear safety goggles, proper apparel, and maintain good footing.
Use the right tool, don't force it, maintain tools with care.
Ensure switch is 'OFF' before plugging in and disconnect for servicing.
Use recommended accessories and check for damaged parts before use.
General