Sears CRAFTSMAN C935-359130

Questions and Answers

L
leonardmcphersonAug 2, 2025
How to troubleshoot Sears Lawn Mower that does not start?
- V
  villanuevabryceAug 2, 2025
  If your Sears Lawn Mower doesn't start, first check that the extension cord is properly connected at both the mower and the outlet. Also, verify that the outlet has power by checking the breaker or fuse. If these steps don't resolve the issue, unplug the power cord, turn the mower on its side, and inspect the blade to ensure it rotates freely and that the mower deck isn't clogged.
J
Jennifer HesterAug 7, 2025
What to do if my Sears CRAFTSMAN C935-359130 Lawn Mower keeps stopping?
- J
  Joseph PrattAug 7, 2025
  If your Sears Lawn Mower stops, release the control switch. This may be due to the mower or house circuit breaker tripping, or a fuse blowing. Also, unplug the power cord, turn the mower over, and clean out the deck to remove any material blocking the blade. Wait two minutes before attempting to restart. Consider walking slower, reducing the cutting width, or raising the mower cutting height.
J
Jamie BrownAug 11, 2025
Why is my Sears Lawn Mower performance so poor?
- R
  Richard PayneAug 11, 2025
  If your Sears Lawn Mower demonstrates poor performance, raise the mower cutting height to cut only 1/3 of the grass length if the grass is too high or thick. Try walking at a slower pace and reduce the cutting width if needed. Unplug the power cord, check the deck for clogging, and inspect the blade for sharpness.
S
smithdianeAug 15, 2025
How to fix excessive vibration in my Sears CRAFTSMAN C935-359130 Lawn Mower?
- R
  robertwhiteAug 15, 2025
  Excessive vibration in your Sears Lawn Mower can be caused by a worn, bent, unbalanced, or loose blade. Unplug the power cord and replace the blade, then tighten the blade bolt. A bent motor motorshaft could also be the cause.
F
friveraAug 19, 2025
What causes an uneven cut with a Sears Lawn Mower?
- D
  Daniel GarciaAug 19, 2025
  An uneven cut from your Sears Lawn Mower may be due to a worn, bent, or loose blade. Unplug the power cord, replace the blade and tighten the blade bolt. Also, unplug the power cord and clean the underside of the mower housing to remove any buildup of grass and leaves.
J
Jody MurphyAug 23, 2025
Why is my Sears CRAFTSMAN C935-359130 Lawn Mower so hard to push?
- R
  rmirandaAug 23, 2025
  If your Sears Lawn Mower is hard to push, it might be because the grass is too high, or the wheel height is too low. Raise the cutting height to resolve this.
E
Emily WestAug 28, 2025
What to do if Sears Lawn Mower doesn't stop when releasing the switch?
- J
  Jennifer FergusonAug 28, 2025
  If your Sears Lawn Mower does not stop when the operator presence control switch is released, it indicates that the operator presence control switch is damaged. Replace the operator presence control switch.

Summary

Safety Instructions

Training and Safe Operation

Learn how to operate the mower safely and understand its controls.

Preparation for Mowing

Check the area, wear safety gear, and dress properly before mowing.

Assembly

Carton Contents and Mower Removal

Identify parts in the carton and safely remove the mower.

Handle and Grasscatcher Assembly

Steps for unfolding the handle and assembling the grasscatcher.

Installing the Side Discharge Chute

Instructions for attaching the side discharge chute to the mower.

Operation

Know Your Mulching Mower Controls

Familiarize yourself with mower controls, adjustments, and safety symbols.

Mowing Procedures and Tips

Guidelines for safe mowing, cord management, and maintenance.

Mulching Operation and Tips

How to mulch effectively and tips for best performance.

Maintenance and Storage

Blade Care and Sharpening

Instructions for removing, replacing, and sharpening the mower blade.

Cleaning and Corrosion Prevention

Methods for cleaning the mower and preventing rust.

Storage Procedures

How to prepare and store the lawn mower for extended periods.

Troubleshooting

Troubleshooting Common Issues

Common problems, their causes, and recommended corrections.

Parts and Service

How to Order Repair Parts

Information on ordering replacement parts, including necessary details.

Sears CRAFTSMAN C935-359130 Specifications

General

Engine	Briggs & Stratton
Engine Displacement	190cc
Deck Material	Steel
Starter Type	Recoil
Cutting Width	21 inches
Drive System	Self-propelled
Oil Capacity	20 oz
Wheel Size	11 inches (front)