Assembly
Place the HUSKE fork mount over the mounting holes in
the rack deck and push the two mounting bolts through
the fork mount and the deck. Place a flat washer over the
end of each bolt and then thread a locking nut onto the
end of the bolt. Using the supplied wrenches, tighten the
locking nuts until secure - the fork mount should be held
firmly in place and should not rock or move when
pressure is applied. See the included HUSKE Fork Mount
Manual for more information.
NOTE - The multiple mounting holes on the Mini Bomber
and Bomber decks allow some flexibility in positioning the
fork mounts. The angle of the fork mounts can be
changed to prevent
wider handle bars from
touching.
Special Instructions for the Bomber
Bomber racks are assembled in the same way as Mini Bomber racks
except that Bomber racks come with a Riser Block that should be
installed under the center fork mount. The Riser Block raises the
height of the handlebars on the bike in the middle position to provide
additional clearance for wider handlebars.
To Next Page
Loading...
