READ THIS BEFORE USING
YOUR SEASUCKER RACK!
WARNINGS
•
Do not mount bicycles backwards, sideways or
at an angle.
•
Do not exceed the posted speed limit.
•
Do not use if the indicator band is exposed on any
of your SeaSucker’s pumps.
•
Do not use if all of the rack’s mounts cannot
maintain a full vacuum seal for at least 4 hours.
•
Check the indicator band during use.
•
Clean the mounting surface before attaching.
•
Clean SeaSuckers before attaching.
•
Clean and lube your SeaSuckers’ pumps regularly.
•
Inspect screws, nuts, and bolts regularly and
retighten if necessary.
•
Do not use for bicycles over 45 pounds.
•
Make sure the fork mount is fully clamped and
secure before you transport your bicycle.
•
Make sure the vacuum pads are fully seated in the
protective covers when not in use.
•
The Falcon rack can not be used on roof top - it is
for pickup truck back window use only.
The Rack’s Responsibility
With all SeaSucker vacuum mounts fully
engaged, the rack will securely hold
bicycles up to 45 pounds each at speeds up
to 75 mph. The rack will indicate if the
SeaSuckers are not maintaining vacuum:
each SeaSucker has a power indicator
band in the pump that will extend out and
become visible upon loss of vacuum. If you
see the indicator band, you must re-pump
the SeaSucker before the rack can be
safely used again.
Your Responsibility
You must inspect the indicator bands on all
SeaSuckers when entering and exiting your
vehicle. A quick glance will tell you if the
rack is at full power. If the indicator band is
visible, you must re-pump the SeaSucker
before the rack can be used. If any of your
SeaSuckers do not hold vacuum for at least
4 hours, they may need to be cleaned,
repaired, or replaced. Your rack comes with
an extra SeaSucker vacuum pump; keep it
with your rack in case you accidentally
damage one.
SeaSucker, LLC
Bradenton, Florida
www.SeaSucker.com
Talon
• Talon deck with three
vacuum mounts attached
• (1) standard 9mm fork mount
• (2) 1.25x1/4-20 hex head
bolts
• (2) 1/4-20 nyloc nuts
• (2) flat washers
• (1) Rear Wheel Strap
• (1) Crank Arm Strap
• (1) Spare vacuum pump
• 5g Lube Tube
• 7/16 box wrench
• 5/32 Allen wrench
Mini Bomber
• Mini Bomber deck with four
vacuum mounts attached
• (2) standard 9mm fork
mounts
• (4) 1.5x1/4-20 hex head bolts
• (4) 1/4-20 nyloc nuts
• (4) flat washers
• (2) Rear Wheel Straps
• (2) Crank Arm Straps
• (1) Spare vacuum pump
• 5g Lube Tube
• 7/16 box wrench
• 5/32 Allen wrench
Bomber
• Bomber deck with five
vacuum mounts attached
• (3) standard 9mm fork
mounts
• (1) 3/4” Riser Block
• (4) 1.5x1/4-20 hex head bolts
• (2) 2.25x1/4-20 hex head
bolts
• (6) 1/4-20 nyloc nuts
• (6) flat washers
• (3) Rear Wheel Straps
• (3) Crank Arm Straps
• (1) Spare vacuum pump
• 5g Lube Tube
• 7/16 box wrench
• 5/32 Allen wrench
Falcon
• Falcon deck with two vacuum
mounts attached
• (1) standard 9mm fork mount
• (2) 1.25x1/4-20 hex head
bolts
• (2) 1/4-20 nyloc nuts
• (2) flat washers
• (1) Spare vacuum pump
• 5g Lube Tube
• 7/16 box wrench
• 5/32 Allen wrench
To Next Page
Need help?
General
