CLIMATE CONTROL –––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
2.53
HANDLING INSTRUCTIONS
Rotary regulator B –
Temperature selection
Right – increases heat output
Left – decreases heat output
When the
air conditioning system*
is
switched on, turning the regulator to the
left increases the cooling performance.
Rotary regulator C – Air distribution
For vent layout, see next page.
Buttons D – Air conditioning
Switched on by pressing button
AC
(cool
air).
A light on the button will come on.
The system is switched off by pressing the
button again.
Buttons D –
Air recirculation switch
This switch can be used to change over to
air recirculation. This prevents badly cont-
aminated air from entering the vehicle,
e.g. when driving through a tunnel.
When the air recirculation system is
switched on, a small warning lamp lights
up in the switch.
The air recirculation system should
only be used for a short period as no
air is then fed into the vehicle from
the outside and the windows will tend
to mist up.
Switch at Vents
…
Vents
…
symbol fully slightly
open open
1, 2 3, 4
5 1, 2, 3, 4
3, 4, 5 1, 2
3, 4 –
IN0-031
To Next Page
Loading...
