●
The system prevents the activation of the ve-
hicle's drive system.
●
The high-voltage battery is not charged.
●
The AUX-IN diagnostic socket is switched o.
●
The anti-theft alarm is switched o.
●
The “Safe” security system is switched o.
After installing the software
After the software installation and before ac-
tivating the vehicle's drive system, read the
message on the Infotainment system or in the
Instrument cluster about the complete installa-
tion of the software. It can take up to 1 minute
for the vehicle to display the status of the over-
the-air update.
●
The vehicle's drive system can be activated
once the software has been successfully instal-
led.
●
If the software installation is not successful:
›››page10, Troubleshooting.
Troubleshooting
The installation of an over-the-air update
has failed.
●
If an update is not installed correctly, an error
message will appear in the infotainment system
or in the instrument cluster. Observe the corre-
sponding messages and warnings.
Note
The control units will stop working or will not
work properly in the event of a critical instal-
lation error. The functions and screens will
not be available until the error is amended.
Do not use the vehicle. In this case, please
contact SEAT customer care.
Can I interrupt the installation of an over-
the-air update?
No, it is not possible.
What happens if the installation of an over-
the-air update is interrupted?
If the installation is interrupted, for example due
to damage to the vehicle's electrical system,
the control units may not be updated and may
not work due to incomplete installation of the
update.
WLAN access point
Configuration for sharing a connec-
tion over WLAN
Depending on the version, it is only possible
to connect in Hotspot mode to get SEAT CON-
NECT, and a maximum of 5 devices can be
connected.
To Next Page
Loading...
