• Seat cushion: The seat cushion on the MONACO™ and MONACO ASSIST™ is a
waterproof, pressure redistributing, breathable, medium foam cushion providing
pressure management and comfort. The seat cushion will have non-slip material on
one face and a zip closure on one side.
To fit the seat cushion to the chair, unwrap the cushion from the plastic packaging.
Ensure the non-slip material is on the bottom and makes contact with the non-
slip material already on the baseboard, with the zip closure at the rear. This is
important as the foam's structure facilitates immersion and envelopment of the body
prominences ONLY when fitted as instructed.
• Sliding footplate: At no point should anyone stand or sit on the sliding footplate.
To use the sliding footplate pull it out to the full position and allow the feet to rest
on it, ensuring they are placed on top of the sliding footplate. Push the footplate in
to its fully retracted position before allowing the Patient to get on or o the chair,
exercising care to stay away from the sliding rail. Adjust the footplate by holding the
front lip.
(fig.6)
Sliding
Footplate
To Next Page
Loading...