• Seat Angle Adjustment:
MONACO™
To adjust the angle of the seat on the chair, the User must inform the Patient then
stand behind the chair, firmly hold the push handle with your right hand and close the
release lever located at the back of the chair (labelled TILT) with your left hand (fig.3).
While closing the release lever place your foot on the step (labelled STEP) and push
down until the seat is at the required angle and allow the release lever to move to its
relaxed position before letting go of the push handles.
MONACO ASSIST™
Using the handset adjust the seat angle to a desired position. The seat will elevate
which will assist the patient to a standing position. The patient should be encouraged
to use their armrests during this elevation for stability and balance.
Please note: do not change the angle of the seat before informing the patient sitting
in the chair
(fig.3)
Wing knobs for
lateral support
adjustment
Braking castors
Release lever for seat
angle adjustment
Back recline
adjustment
Step for seat angle
adjustment
Push handle
To Next Page
Loading...