SECRETLAB CHAIR SKIN USER MANUAL
Slide the backrest sleeve over your chair and
pull it down the seat's backrest.
02
Unzip the side and bottom zippers.
01
Ensure holes on the backrest sleeve align
with the lumbar knobs on the chair wings.
03
Once the backrest sleeve is securely on, zip
down the zippers on either side of the
backrest sleeve and adjust for a snug fit.
04
Locate two straps at the base of the backrest
sleeve. Route them through the gap between
the seat’s backrest and seat base, then tug
gently to reinforce fit.
06
Pull both straps upward and
tuck them in.
07
Connect the top and bottom zipper of the
upper and lower backrest sleeve and zip
close. If straps slip out, simply tuck them
back upwards and continue zipping.
08
Incline the backrest all the
way forward.
05
Adjust backrest sleeve for the best fit.
Starting from the chair’s side wings, lightly
tug the sleeve inwards or outwards to align
the seams and accents of the sleeve with the
edges of your chair.
09
Before you get started, a few pointers:
Please ensure that your chair is free from visible dust or dirt before installation.
Adjust your armrests horizontally to their most outward positions.
Optional: Use a cloth iron on low heat to smooth out any minor creases in either sleeves before assembling.
●
●
●
BACKREST SLEEVE ASSEMBLY
PAGE 1 OF 2
To Next Page
Need help?
General
