USing the chrOnOgraPh
This chronograph can measure and display the time in an interval ranging from 1 second
to a maximum of 30 minutes.
meaSUring time With the chrOnOgraPh
1 - Start or stop the chronograph by pushing button
2 - Press button B to reset the chronograph and to return the dials of counters H9 and
H6 to 0
reSetting the chrOnOgraPh
Attention: You should perform this procedure when the chronograph seconds dial (coun-
ter H6 ) does not return to 0 after the chronograph is reset as well as after the battery
is replaced.
1 - Pull out the crown to “second click” position
2 - Push button A (to turn the dials clockwise) or B (to turn the dials anticlockwise) to
position the seconds counter dial ( H6 ) to 0
3 - Once the dials have been reset, set the time according to the above instructions and
return the crown to its normal position
To Next Page
Loading...
