Subject to modifications
-- page 1 --
SELO-C-Standard-Betriebsanleitung-englisch.p65
Date: 12.06
Operating instructions - Basic functions
of electronic lock SELO-C (Version 1.0)
Fully redundant electronic lock model SELO-C allows you to open the lock after entering the valid 7- or 8-digit secret code. The
maximum number of codes for clearing the lock is 10.
A) GENERAL
- The opening procedure consists of two operations: CLEARING and UNBLOCKING.
- To start the opening procedure, check that the input unit is in the vertical end position.
- All accepted key strokes will produce a response on the display.
- If the code number is keyed in by mistake, return to the starting position of the lock by pressing the On/Enter key, and start
over.
- After entering the wrong secret code three times in a row, the lock will automatically block all further entries for 5 minutes.
If, after waiting for 5 minutes, the wrong code is entered again, the lock will block itself for a further 20 minutes
(manipulation resistance). During this time, the remaining delay is depicted on the display and not even the valid number
code will open the lock.
- If more than 30 seconds lapse between pressing any two keys, the lock automatically switches itself off for safety reasons.
The opening procedure has to be started over.
- Once data have been stored (numerical codes, time frame and user entries), not even a power failure will delete them.
- The lock is of fully redundant design. This means that all electrical components which are crucial to the proper functioning
of the lock come in pairs. In the unlikely event of the primary system breaking down, the lock can, therefore, always be
opened undamaged using the secondary or backup system.
3 lines for entering codes and
displaying messages
1 line for displaying battery
condition and key functions
Function key for correcting data
input and selecting menu
functions
On/Enter-key to switch on the
unit, select functions and to set
the lock to its starting position
Rotary handle for unblocking
the lock
Multifunction keys „2“ , „4“, „5“,
„6" and „8“ for moving the cursor
and entering the code
Keys „0“ - „9“ for entering
numbers and plain text
- Battery condition „1/3 full"
- Key marked „Function“ to return
to next higher menu level
- Keys „1“ and „2“ to navigate
through the menu
- Battery condition „full“
- Key marked „Function“ to select
the desired menu from the
setting mode
- Battery condition „2/3 full"
- Key marked „Function“ for
deleting the figure entered last
- Battery condition „almost empty"
Multifunction keys „1“ and „2“
for entering figures and words,
and for menu navigation
To Next Page
Need help?
General