Peanut Plug - Quick Start Guide
MODEL : PP1-WHT-US
Adding to Almond
1. Peanut Plugs must be added one at a time.
2. Insert the Plug into a power outlet. If the LED is not blinking, Reset the Plug as per below instructions and
then start over from Step1.
3. On the Almond touchscreen, tap the Add Sensor icon and then tap Add. The touchscreen should now
display the message “Adding sensor…”
Resetting the Peanut Plug
Reset the Plug by pressing the pairing button (<Button Symbol>) for 10 seconds and then releasing it.
Remove the Plug from the power outlet and plug it back in.
Monitoring & Controlling the Plug
1. The Toggle button (<Button Symbol>) on the Plug can be used to manually switch the plug and its attached
appliance on and off.
2. The Plug can also be monitored and controlled via the Internet using our free Almond iPhone and Android
apps or from a standard web browser (http://connect.securifi.com).
3. In case the Almond can’t access the Internet, you can also monitor the Peanut Plug via the Connected
Home app on the Almond’s touchscreen or via the Almond’s local web user interface (default:
http://10.10.10.254)
Operating Conditions
Indoor Use Only
Temperature: 0 to 40C (32 to 104F)
Humidity: 0 to 80%
Altitude: Up to 2000m (6500 ft)
Caution
1. Make sure the Peanut Plug is OFF before plugging an electric appliance into it.
2. Unauthorized changes or modifications to the Peanut Plug will void its warranty and could seriously
compromise its safety or efficacy.
3. Protective earthing: Ground pin must not be removed from the device.
4. Make sure an active Peanut Plug is easily accessible and can be disconnected quickly.
5. Unplug device prior to cleaning. Use dry cloth on exterior of the device. To avoid shock hazard and/or
damage to device, DO NOT use any liquid solution.
6. Install and use Peanut Plug in accordance with the appropriate Electrical Codes and Regulations
7. Do not install near heat sources or in humid areas
8. When operating under heavy loads, the Peanut Plug may heat up considerably. Allow it to cool before
manually removing it from an electrical outlet.
To Next Page
Need help?
General
