Seedo Auto Grow Home Device

To Next Page

1. Unpack and Install Seedo

2. Install Seedo App

3. Install Seedo Consumables

3.2 Water ﬁlter

3.1 CO2 cylinder

3.3 Carbon air ﬁlter

Auto Grow Home Device

Quick Install Guide

Initial

Installation

• Place Seedo close to power and if possible also

to water supply and drainage.

• Connect power cable to Seedo and plug in.

• Turn On Seedo switch (at back of device).

• Press Seedo’s door opening button at top center.

• Remove all cartons, blue tapes, pink covers on

irrigator pins.

• Download app from App Store or Play Store.

• Read and agree to terms of use and conditions.

• Open service door on top of Seedo.

All the installation videos are available on

the app and can be found also on Seedo’s

Youtube channel.

• Insert cylinder and turn

clockwise as far as possible.

• Do not remove cylinder after

you hear a hissing noise.

• Remove blue cap from the lter.

• Filter is notched and can

only be inserted in one position.

• Push rmly, then turn lter

clockwise until it locks in.

• Remove the plastic lter

cover from its slot by pressing

both sides inwards.

• Insert air lter and replace

plastic cover, ensuring that

snaps are secured in place.

Need help?

Do you have a question about the Seedo Auto Grow Home Device and is the answer not in the manual?

Summary

Initial Installation

Unpack and Install Seedo

Place Seedo, connect power, turn on, open door, and remove packaging.

Install Seedo App and Consumables

Download app from store and install CO2 cylinder, water filter, and carbon air filter.

Install Fertilizing Solutions and Rockwool

Insert suction hoses into nutrient bottles and place rockwool slab in tray.

Connect Water, App, and WiFi

Connect water supply/drainage, then link Seedo to the app and home WiFi.

Configure Seedo Settings

Name your Seedo and specify water source and drainage method.

Pre-planting Setup

Choose Growth Plan and Type

Select growth plan from categories and choose seed or clone planting.

Install pH Sensor

Prepare pH sensor by removing tape/cup, then insert firmly into its compartment.

Prepare Rockwool Slab for Planting

Wait for slab watering, then make incisions and flip slab for planting.

Planting Seeds

Planting Clones