Need help?Do you have a question about the Seeley coolair Braemar Breezair MaglQtouch and is the answer not in the manual?
General| Control Modes | Manual, Auto, Timer |
|---|---|
| Wireless Control | No |
| Type | Controller |
| Compatibility | Braemar, Breezair |
| Display | LCD |
Details on the 6-core flat communication cable and its specifications.
Step-by-step installation wizard for controller commissioning.
How faults are displayed, diagnosed, and resolved via the service menu.
Explains the intuitive touch screen and new operational features.
Guidelines for controller placement and maximum recommended cable lengths.
How to mount the optional air sensor for flexible placement.
Describes the Link Module for connecting multiple MagIQtouch products.
Correct cable connections and dipswitch configuration for the Link Module.
Importance of unique addresses and steps before powering the system.
Visual representations of single, multi-cooler, and gas ducted heater systems.
Steps for single component and multi-component installations using the wizard.
How to perform a full system or controller reset using the reset button.
Overview of General, Cooler, and Service menus, including key settings.
How faults are detected, displayed, and managed via fault categories.
Using the screen for component testing and troubleshooting.
Step-by-step guide to access and alter controller parameters.
Changing between MagIQtouch and MagIQcool controllers.
Procedures for integrating controllers into existing or new systems.
Essential specifications and component information for these models.
Details on the electronics box and drain valve setup with shorting plug.
Explains fault codes indicated by LEDs on the cooler electronics box.
Procedures for testing fan motor resistance and removing the fan assembly.
Steps for correctly reassembling the fan motor into the cooler.
Instructions for refitting pad frames and specific notes for EZQ models.
Specifications and component data for these Braemar/Coolair models.
Cooler electronics, drain configuration, fault codes, and salinity LED indicators.
Specifics for LCQI cooler, including diagnostics, motor replacement, and voltage monitoring.
How the Prewet function ensures pads are wet before fan activation.
Using the Service Operating Screen to test pump, solenoid, and drain valve.
Procedure for adjusting the water level using the float valve.
Details on the BMS M1 controller, inputs, outputs, and Master/Slave modes.
Explains the simple control functions of the Switch Plate Controller.
Routine checks for pad frames, water system, fan motor, and electrical components.
Information on accessing the Seeley Service & Spares Web Resource.
Correct procedure for installing TQ heater to existing FEAC cooler.
Tips for ensuring secure communication cable connection for controllers.
Notes on pad thickness and rebates for EXS model cooler pad fitting.
Explanation of ICON fan speed LED behavior for diagnostics.
Requirements for electrical circuit protection when installing Icon Coolers.
Electrical power supply specifications for Breezair EXH & EZH Icon.
Checks required during commissioning of Breezair Icon Series Evaporative cooler.
Water supply specifications for FEAC Coolers (Breezair, Braemar, etc.).
Guidelines for routing data/comms and 240V cables to prevent interference.
Common issues and their solutions for MagIQtouch system installation.
Answers to common queries regarding controller compatibility, modes, and cooler operation.
To Next Page
