•Avoid accidental starting. Be sure switch is off before
plugging in. C arrying tools with your finger on the switch or
plugging in tools that have the switch on invites accidents.
•Remove adjusting keys or wrenches before turning the
tool on. A wrench or a key that is left attached to a rotating
part of the tool may result in personal injury.
•Do not overreach. Keep proper footing and balance at all
times. Proper footing and balance enables better control of
the tool in unexpected situations.
•Use safety equipment. Always wear eye protection. Dust
mask, non-skid safety shoes, hard hat, or heanng protection
must be used for appropriate conditions.
TOOL USE AND CARE
•Use clamps or other practical way to secure and support
the work piece to a stable platform. Holding the work by
hand or against your body is unstable and may lead to loss of
control.
•Do not force tool. Use the correct tool for your application.
The correct tool will do the job better at the rate for which it is
designed.
•Do not use tool if switch does not turn it on or off. Any
tool that cannot be controlled with the switch is dangerous
and must be repaired.
-2-
To Next Page
Loading...