The meter will turn back light off if there is
no push button for 30 seconds.
4.8 Low Battery Condition:
When the battery voltage is under proper
operation requirement, the “ ” symbol
will show and flash on the LCD and the
battery needs to be replaced.
4.9 Beeper Off:
Press and hold the button and then
power on the meter. The mute beeper icon
“ ” is shown on the display. To
re-enable the beeper, turn the meter off
and then turn it back on.
4.10 Battery Replacement:
(1) Back out the screw at the bottom of the
battery door and lift the door away from
the meter.
(2) Remove the four AA batteries from the
To Next Page
Loading...